Not surprising but I'm glad a famous 3d printing youtuber points it out.

My printer is set in an Ender tent, it's like a grow tent and it's connected to the ventilation system in our apartment. Everything gets vented outside.

Also due to static electricity most particulates will stick to the air tubing. Which is good because it will agglomerate and is therefore easier to get rid of.

Microplastics and VOCs are bad mmkay. If you can smell it you're doing it wrong.

Ackschually

PLA is not abrasive by itself but it's additives might be. Titanium dioxide is a common colorant for example which might end up eroding your nozzle slowly.

So mid print, pause and resume just like with replacing a filament roll.

I guess you're too straight edge for that.

People ignore that.

Churches!

Also the civilized world.

What's so funny about Biggus Dickus?

Howtobasic has entered the chat.

I only tip when on vacation in countries like Vietnam. Since a few euros is a lot of money there.

Anywhere else not.

You work with Colin Robinson?

You can't get fooled again?