overview for aniki

Watching my girlfriend just accept every pop up was maddening. I've been teaching her about unsubscribing, 10 minute email, reject all, and firefox add-ons.

Amazon Mulls $5 to $10 monthly price tag for unprofitable Alexa service, AI revamp in c/technology@lemmy.world

[-] aniki@lemm.ee 42 points 2 months ago

Home Assistant will always be free.

Amazon Mulls $5 to $10 monthly price tag for unprofitable Alexa service, AI revamp in c/technology@lemmy.world

[-] aniki@lemm.ee 5 points 2 months ago* (last edited 2 months ago)

You can do that right meow. Not ChatGPT but open source models.

I Will Fucking Piledrive You If You Mention AI Again — Ludicity in c/technology@lemmy.world

190

Finally! My own working LCARs panels! (lemm.ee)

submitted 6 months ago by aniki@lemm.ee to c/homeassistant@lemmy.world

22 comments fedilink

I've been putting this off for way too long but I finally installed the LCARs theme in my HA and got to work redesigning all my dashboards.

5

ESPHome advanced troubleshooting (lemm.ee)

submitted 7 months ago* (last edited 7 months ago) by aniki@lemm.ee to c/homeassistant@lemmy.world

9 comments fedilink

I started mucking about with ESPHome yesterday and setup a WROOM with an AHT22 temp/humidity sensor. Running the wizard and adding the configs is easy-peasy. I started to have issues as soon as I wanted to flash.

If the AHT22 is plugged in, I cannot flash the device over USB.
I can check the serial logs once the device is flashed and then plug in the AHT22 once the device is booted and get readings, but
Once I unplug the ESP32 from the serial port and plug it into a power supply, I got nothing. No network activity at all.
Unplug the AHT22, plug into the power source, wait a few seconds, plug in the AHT22 has seemed to work correctly this morning and HA is pulling data but I tried that last night a few times and it didn't work -- so unsure why it's working this morning other than strange timing when I'm plugging the thing back in.

I am using the basic esp32dev firmware, which I am assuming works because it DOES work, eventually, but I'm not confident I'm using the right base but I cannot figure out which one to use.