sorted by: new top controversial old

Can You Inject Hot Glue Into 3D Printed Molds? | DIY Cable Repair & Protection - spoiler: yes, it's neat in c/3dprinting@lemmy.world

[-] WaltzingKea@lemmy.nz 4 points 2 months ago

Yeah I guess heat-shrink would do the job most of the time. But for when you have connectors that are too big to fit the right heat-shrink over or want to splice more than 2 wires together and want a waterproof seal over them this could be useful.

permalink
fedilink
source
context

What does your current setup look like? in c/selfhosted@lemmy.world

[-] WaltzingKea@lemmy.nz 13 points 8 months ago

Bad. I have a Raspberry Pi 4 hanging from a HDMI cable going up to a projector, then have a 2TB SSD hanging from the Raspberry Pi. I host Nextcloud and Transmission on my RPi. Use Kodi for viewing media through my projector.

permalink
fedilink
source

WaltzingKea

joined 1 year ago