Total clog with prusament pla in line. Can't feed anything through even at high heat. Cold pull not possible / filament not making it into hot end to do this.

You can see little bit of filament sticking out in photo, but with pliers this just tears.

Should I try heating up the whole hot end tube with a soldering iron to see if I can liquify the clog out?
Any other ideas? I can't find many good resources about what to do in this situation online. Also, obviously needs to get cleaned up a bit, but does picture of my hot end tip look pretty ok? Do I need to bite bullet and get a new hot end? If so, are Amazon off brand replacements ok, or do I need to wait for one to get shipped from prusa?

Thank you

Looking for more modern high quality files for a QRS player piano system. New to this, but it seems like midi files are the most likely to find since specialty qrs / player piano file formats seem nearly nonexistent on the internet. Having a hard time finding copyrighted more modern (most available internet midi files for piano are from 1800s) song libraries of decent quality. Can anyone here point me in the right direction?

I finally got a filament drying box and I'm using it prior to and during prints. It seems to be helping. I'm a bit of a color queen, so I keep a pretty big backlog of different filaments. I've been storing them in vacuum bags but the vacuum bags often seem to lose some of their vacuum after a few months; the whole process is a bit of a pain. Is this really worthwhile or as long as I'm using the drying box can I forgoe the vacuum storage? If vacuum storage is still a good idea, are there better bags I should be looking for that don't lose some of the vacuum after a few months or is that pretty standard?

I think it's finally time for a dryer box. Want something I can run filament out of directly to the printer. Right now considering space pi vs. Esun vs. Eibos. Ideally something I could run for just a little while before a print and during the print. Low noise also important. A decible chart for dryers would be nice if that exists. Any favorites or good ones I am not considering?

Where do you find large collections of hi res art? Old masterpieces and more modern pieces? Extra points if I can find stashes of hi res versions of NFTs that other people were silly enough to buy.

Heard I can use acetone for PLA, but not for PETG. Glued a joint and there is residue extruded and unfortunately it's a very shiny / translucent PETG. Any suggestions for cleaning up thin white residue stain from the cyanoacrylate?

Right in the middle of an absolutely massive print this x axis shift occurred. MK4 printer. Printer ran a calibration just prior to print. Once my tears dry up, and I buy some more filament, how do I prevent this from happening again when I retry this?