Glad to be of help!

The FAN1 in this case can not be controlled by software. It will always be on as soon as the printer is powered.

Then suddenly all VPN providers will be „commercial“.

An exclamation mark (!) inverts a pin. The other symbol (^) enables a pull up resistor on a pin, which is needed for things like endstops or buttons. These can also be combined.

PB0 is just the name of one pin. PC0 would be a completely different pin.

Different Microcontrollers have different naming conventions, that is why you sometimes see names like PB10 and on other controllers it might be GPIO10.

See also the documentation: https://www.klipper3d.org/Config_Reference.html

So how would that work? You can not distinguish between commercial or private use, because the traffic is encrypted, you don’t know what is transmitted, that is the whole point.

The printer.cfg is highly dependent on your setup. For reference you can look at the example config for the SKR mini e3 v3: https://github.com/Klipper3d/klipper/blob/master/config/generic-bigtreetech-skr-mini-e3-v3.0.cfg

Well. Why would you want to do that?

In the end, choose the board that has the features you need. Software is the same anyway.

With Klipper you can even combine multiple boards to get the features you want.

That sound like it would wobble and easily tip over, no?

PA is also way too low (if it is even set at all). It could reduce the „thickening“ of the lines at each end dramatically.

So these are blocked on a DNS Level? So just using a different DNS (like 9.9.9.9 or 1.1.1.1 or 8.8.8.8) will get around this „block“

You happen to have a link for that? Sounds very interesting

Jokes on them, windows is and has been my secondary OS for years now. If it causes problems, I have no problems just deleting it.

Reminder for everyone who does not know: doctor who is available on the bbc iplayer, which can be downloaded with get-iplayer.

If you are outside the UK, all you need is a DNS or VPN.