19
First Time Using A Stencil (Summercart 64) (i.imgur.com)
submitted 9 months ago by v1605@lemmy.world to c/soldering@lemmy.ca
4 comments fedilink hide all child comments

This was the first time I've used a stencil and solder paste to build up a pcb. It was so much easier to get all the components aligned and soldered on the board (on the back, there are 38 0603 capacitors which are always time consuming to hand solder). After just had to clear a few bridges and added a little extra solder to U1.

Project link

you are viewing a single comment's thread
view the rest of the comments
[-] v1605@lemmy.world 2 points 9 months ago

I'll have to keep this in mind if I ever go down the home PCB fabrication root.

this post was submitted on 24 Dec 2023
19 points (100.0% liked)

Soldering

424 readers
2 users here now

This community is for electronic hobbyists to discuss projects and is focused on soldering. Everyone is welcome from the noob to people who have been soldering as a hobby for decades to people who solder professionally. We'll talk about materials and techniques, equipment, and projects. Everyone is welcome. All questions are welcome. Post photos and ask for help.

RULES:

  1. All Lemmy.ca rules apply here.

  2. Everyone (see rule 98) is welcome.

  3. If you’ve seen a question 100 times answer it the 101st time or ignore it. Even better, write a complete, detailed answer and suggest that the mod(s) pin it to the community.

[Did you actually think there were 98 rules?]

  1. If you present something as fact and are asked to provide proof or a source provide proof or a source. Proof must be from a reliable source. If you fail to provide proof or a source your post or comment may be removed.

  2. Don’t be a dick. Yes, this is a catch-all rule.

  3. The mod(s) have the final say.

founded 1 year ago
MODERATORS
MapleEngineer@lemmy.ca