598
you are viewing a single comment's thread
view the rest of the comments
[-] rotopenguin@infosec.pub 65 points 10 months ago* (last edited 10 months ago)

An AAAA cell has 200-350 mohms internal resistance. A 9v battery has 6 of them in series (many of them are literally that, others have their cells as a stack of plastic buckets). The nose ring is a short run of wire, it's idunno a 0.2 ohm heater?

I think the septum is going to get pretty toasty.

https://data.energizer.com/pdfs/e96.pdf

[-] Enkers@sh.itjust.works 55 points 10 months ago* (last edited 10 months ago)

I just tested this (for science!) with a 9V battery and an iron nail of roughly nose-ring diameter. Both the nail and the battery get unpleasantly hot after several seconds. I don't think they'd get hot enough to burn you, though. (Don't take my word, though, please!) I believe the internal resistance of the battery does also increase with the temperature, so it effectively somewhat self regulates itself.

Common nose ring materials like Titanium and Stainless Steel are 4× and 7× more resistant than iron, which means they should dissipate more power than the nail, and thus get hotter. I was calculating something around 3 milliohms for a titanium 16 gauge 10mm wire, and 0.7 milliohms for an iron wire.

Regardless of material, at 1000 milliohms internal resistance, i think the battery itself is doing most of the heat dissipation. (But also over a much bigger surface area!)

load more comments (5 replies)
load more comments (9 replies)
this post was submitted on 23 Nov 2023
598 points (96.0% liked)

Memes

45180 readers
1493 users here now

Rules:

  1. Be civil and nice.
  2. Try not to excessively repost, as a rule of thumb, wait at least 2 months to do it if you have to.

founded 5 years ago
MODERATORS