This was solved!!
Don't know where to draw the line and say this is either a Windows post or a Linux post, but I'd rather post here because this community is more active.
To make the story short, I'm new to Linux and trying to make a jump to it in the future, but for now I decided to dual boot with W11 on my other drive until I understand what I'm doing.
Anyways, before I did a clean install of Win11, I had 2 SSDs like this:
- Disk0 - Windows installed
- Disk1 - Fedora installed
I wanted to clean my system and start over, and also wanted to try Endevour OS so I could later try Arch, but after doing a W11 clean install, my SSDs look different (see picture posted)
Now, I feel like my question is really basic. I specifically checked that W11 needed to only install on Disk0, so I don't know why Disk1 has some partitions:
If I remove/format Disk1, will I lose the whole OS and prompt me to install Windows again? Or should I just install it again regardless so I can install Linux (EOS) on the other drive?
Sorry if this is not a Linux question specifically, sorry if it's a stupid question and thank you in advance for any responses!
Is it possible that disk 1 is your old Linux install? I notice that it doesn’t specify NTFS for the partition type so perhaps you’re just seeing your old EXT partition? If you’re not afraid to lose that data, run diskpart from the cmd, then type “select disk 1” then “clean”. That will wipe it of any partitions and allow you to start fresh.
Yeah, I feel stupid, I'm sorry.
So when I had Windows installed before, Windows was separated into 4 partitions, (not sure why), and then I installed Fedora on Disk1 (secondary SSD), and it looked to me (emphasis in "looked to me") like it was only one whole partition.
However, after doing a clean W11 install it showed up as a single partition (which I was not used to) and Disk1 separated into 3 partitions, and aside from that, my laptop was no longer giving me the option to boot into either W11 or Fedora, it was just going straight to W11. That's where my confusion was from and since I already had installed everything I needed I didn't want to lose the progress.
I went to BIOS and it showed me that the boot menu was F12 (I didn't know this before) and lo and behold, I am once again able to enter Fedora, it was just me being a noob and not knowing any better. Sorry for wasting everyone's time! :(